At the heart of the Sigma LW range of antennas is the 9:1 UNUN. This provides a feedpoint for the long wire radiating element and converts the impedance from 450 Ohms (+/-) to something nearer to the 50 Ohms expected by your transceiver. There are three connections on the UNUN , a SO-239 to which you connect the coaxial feed line and two machine screws with butterfly wing nuts. One of these has the wire antenna connected to it and the other is for you to connect a length of wire to earth. This is not strictly a necessary connection but will reduce static pick up and provide a direct to earth for any possible lightening strike or build up of static in the air. The best way to do this is to attach a length of wire to a ground rod and fix it to the UNUN at this terminal. Fix the feed point up as high as possible – it may be attached to a pole or to a wall and then attach the other end of the wire to a point as far away as is possible. This is best done if the wire can be kept in a straight line and horizontal but , if this is not possible due to space restriction, do not despair. The wire may be dog legged, sloped or fixed in any number of ways to enable it to fit in a space available.
The LW-10 will operate on all HF bands from 40 m to 6 m
with an external ATU. The other end of your coaxial cable should be attached to your ATU and then from the ATU to your transceiver. The power rating is for intermittent amateur
(400W CW or 500W SSB) use and not for AM broadcast or constant carrier data modes. For AM broadcast a much higher power BALUN is required.”
Technical specifations:
- Type: End Fed Wire Antenna
- Frequency: 7 – 52 MHz
- Band: 40-6m
- Power handling 400W, RF
- Impedance 50 Ohms
- Connector SO-239
- Length 10.14 Meters
- Non-Kink Poly Weave Wire
Inhoud verpakking
- 1 x Sigma LW-10 Antenne
- Handleiding
